PX

I2C WORKBENCH & AVR FLASHER

Hardware Telemetry · WebSerial Engine

DISCONNECTED

Serial Control RS232/UART

Telemetry

Hardware PortNONE
Serial Streamclosed
Acknowledged0 devices
Addr Range0x01–0x7E
Scan Cycles0
Bus StatusREADY
RX Bytes0

Bus Actions

Live Wiring Demo Arduino Uno + SSD1306

ARDUINO UNO ATmega328P USB SSD1306 · 128×64 I2C SCANNER READY
SDAA4 → SDA
SCLA5 → SCL
VCC5V → VCC
GNDGND → GND
— board is powered off —

I2C Bus Address Map 0x00 – 0x7F

ACK probing idle

Acknowledged Devices 0 found

AddressDevice IDDescriptionStatus
No peripheral nodes detected yet.

Under the Hood Wire.endTransmission()

ASCII Schematic

   [ ARDUINO UNO / NANO ]      [ I2C OLED ]
  +----------------------+     +------------+
  |                 5V   |---->| VCC        |
  |                 GND  |---->| GND        |
  |           A5 / SCL   |---->| SCL        |
  |           A4 / SDA   |---->| SDA        |
  |                 USB  |==>   +------------+
  +----------------------+  Serial @ 9600

Handshake Logic

Wire.beginTransmission(address);
byte error = Wire.endTransmission();

if (error == 0) {
  // ACK — device present
} else if (error == 4) {
  // Bus error
}
Why it works: The sketch loops 0x01 → 0x7E, sending a zero-byte transmission. If a device ACKs, Wire.endTransmission() returns 0. UI resolves names from a 25-entry table.

AVR Firmware Flasher STK500v1 · ATmega328P

Arduino Uno / Nano ko bina IDE ke flash karein. Drop a compiled .hex file below.

⬆
Drag & drop .hex file or click to browse
Intel HEX format · max ~32 KB flash
Ready to flash0%

Hardware Pin Mapping I2C WIRE

LineUno / NanoMega 2560ESP8266
SDAA4Pin 20D2 (GPIO4)
SCLA5Pin 21D1 (GPIO5)
VCC / GND5V / 3.3V + Common Ground

Serial Diagnostic Telemetry

--:--:--[BOOT] Workstation core online. WebSerial backend ready.
--:--:--[INFO] Connect board running displayidscanner.ino or flash demo.hex.
--:--:--[INFO] Press SIMULATION DEMO or POWER ON BOARD to explore.
--:--:--PORT_CLOSED · 0 lines captured